Lenovo 4XB7A13634 internal solid state drive 2.5
$517.59
3
Brand: Lenovo
Product Code: 4XB7A13634

Retrieving Inventory...
-
+
The Intel S4610 Mainstream SATA solid-state drives (SSDs) for Lenovo servers are advanced data center SSDs optimized for mixed read-write performance, endurance and strong data protection. The drives are available in either 2.5-inch or 3.5-inch drive form factor.

This product guide provides essential presales information to understand the S4610 SSD offerings and their key features, specifications, and compatibility. This guide is intended for technical specialists, sales specialists, sales engineers, IT architects, and other IT professionals who want to learn more about S4610 SSDs and consider their use in IT solutions.

The Intel S4610 Mainstream SATA solid-state drives (SSDs) for Lenovo servers are advanced data center SSDs optimized for mixed read-write performance, endurance and strong data protection. Compared with the Intel S4600 series, these new drives offer improved performance and lower latency.

The Intel SSD S4610 drives with 3 full drives writes per day (DWD) are an excellent choice as cache in transactional application and high-speed storage for enterprise databases.

The Intel S4610 Enterprise Mainstream SATA solid-state drive is shown in the following figure.

By combining the Intel 3D NAND TLC Flash Memory technology and Intel’s latest controller, the design of Intel S4610 Mainstream SATA SSDs delivers consistent performance, reduced power consumption, and end-to-end data protection, as well as being optimized for endurance and IOPS/watt.

Rigorous testing of Intel S4610 Mainstream SATA SSDs by Lenovo through the ServerProven® program ensures a high degree of storage subsystem compatibility and reliability. Providing additional peace of mind, these drives are covered under Lenovo warranty.

The key difference between Performance SSDs such as the S3710 SSDs, Mainstream SSDs such as the S4610 SSDs, and Entry SSDs, such as the S4510 SSDs, is their endurance (life expectancy). SSDs have a huge, but finite, number of program/erase (P/E) cycles, which determines how long the drives can perform write operations and thus their life expectancy. Mainstream SSDs have better endurance than the Entry SSDs, but at a higher cost/IOPS ratio.

SSD write endurance is typically measured by the number of program/erase cycles that the drive can incur over its lifetime, which is listed as TBW in the device specification. The TBW value that is assigned to a solid-state device is the total bytes of written data that a drive can be guaranteed to complete. Reaching this limit does not cause the drive to immediately fail; the TBW simply denotes the maximum number of writes that can be guaranteed.

A solid-state device does not fail upon reaching the specified TBW, but at some point after surpassing the TBW value (and based on manufacturing variance margins), the drive reaches the end-of-life point, at which time the drive goes into read-only mode. Because of such behavior, careful planning must be done to use SSDs in the application environments to ensure that the TBW of the drive is not exceeded before the required life expectancy.

For example, the S4610 960 GB drive has an endurance of 6.0 PB of total bytes written (TBW). This means that for full operation over five years, write workload must be limited to no more than 3,288 GB of writes per day, which is equivalent to 3.4 full drive writes per day (DWPD). For the device to last three years, the drive write workload must be limited to no more than 5,479 GB of writes per day, which is equivalent to 5.7 full drive writes per day.
Certificates
Certification FCC, CA/CSA-CEI/IEC, EN 55024, EN 55022, EN-60950-1, UL/CSA, C-Tick, BSMI, KCC, WEEE
RoHS compliance Y
Design
SSD form factor 2.5"
Endurance
Mean time between failures (MTBF) 2000000 h
Features
Data transfer rate 6 Gbit/s
Memory
Component for Server/Workstation
Memory type 3D TLC NAND
Read speed 560 MB/s
Write speed 510 MB/s
Networking
Security algorithms 256-bit AES
Operational conditions
Non-operating vibration 3.13 G
Operating relative humidity (H-H) 5 - 95%
Operating shock 1000 G
Operating temperature (T-T) 0 - 70 °C
Operating vibration 2.17 G
Storage relative humidity (H-H) 5 - 95%
Storage temperature (T-T) -55 - 95 °C
Other features
Uncorrectable Bit Error Rate (UBER) <1 sector per 10^17 bits read
Performance
End-to-End Data Protection Y
Hardware encryption Y
Hot-swap Y
Latency (read) 36 µs
Latency (write) 37 µs
NVM Express (NVMe) supported N
Random read (4KB) 96000 IOPS
Random write (4KB) 44500 IOPS
S.M.A.R.T. support Y
TBW rating 3000
Ports & interfaces
Interface Serial ATA III
Power
Power consumption (average) 2.9 W
Storage
Solid-state drive capacity 480 GB
Technical details
Maximum operating altitude 3050 m

Write a review

Note: HTML is not translated!
Bad           Good
Captcha